Clear Interior Varnishes

Amteco Quick Dry Varnish

A Low Odor Quick Dry Varnish

Quick Dry Varnish:
 $ 25.00 - 1 Gallon

$ 9.00 - 1 Quart

order Amteco Quick Dry Varnish

Product Codes:

QDV-3200 Satin, QDV-3201 Semi Gloss, QDV-3202 Gloss

Material Preparation:

Mix thoroughly before using. No thinning is required or recommended.

Surface Preparation:

All surfaces must be clean and dry before application.

New wood: Sand bare wood with the grain using fine sand paper. Stain if desired. For best results on open grained woods such as walnut, oak and mahogany, fill with paste wood filler as directed.

Previously finished wood: Sand and clean sound finishes. Remove unsound finishes with appropriate paint and varnish remover. Amteco BST 100 is the recommended varnish remover for previously sealed or varnished surfaces. Then sand and clean.

Application:

Apply by spray, brush or roller (1/4 - 3/8" roller cover). Roll at moderate speeds, and avoid excessive rolling to prevent foaming. Apply two or three uniform coats at 500- 600 sq. ft. per gallon per coat. Avoid thicker coats. May be recoated without sanding after three hours. If not recoated after three hours, allow to dry overnight, then sand lightly and clean before applying another coat.

Drying:

Dries to touch in 30 minutes, to recoat in three hours and to sand overnight at 70°F and 50% relative humidity, and when applied at the recommended coverage rate. Allow longer dry times if cooler more humid conditions exist, or if thicker films are applied.

Limitations:

Do not tint. Thinning is not advised. Do not use over existing solvent or water-borne varnishes and wood finishes.

Cleanup: 

Clean up spills and splatters immediately. Clean painting tools with mineral spirits. Follow manufacturer’s recommendations for thorough spray equipment maintenance.

Typical Properties:

Gloss (60°):         30-45 Satin

                               55-65 Semi-gloss

                               > 75 Gloss                                         

Weight Solids:    35 +/- 2%

Volume Solids:   26 +/- 2% 

Viscosity:             35-45" #3 Zahn Cup        
Flash Point:         55°F (TCC) 

Finishes:

  • Quick Dry Varnish Satin (QDV-3200)

  • Quick Dry Varnish Semi Gloss (QDV-3201)

  • Quick Dry Varnish Gloss (QDV-3202)

 

Amteco Quick Dry Varnish

A Low Odor Quick Dry Varnish

 

Quick Dry Varnish:
 $ 25.00 - 1 Gallon

$ 9.00 - 1 Quart


order Amteco Quick Dry Varnish

Quick Dry Varnish | Application and Properties GuideAmteco BST-100  | MFG Sealants